I started by adding a line of hot glue to the inside of the wreath form and pressing the nautical rope firmly on top. I found that laying the wreath form down and then adding the glue and nautical rope was easier and created a better ring on the inside that was straight. I repeated this through the inside adding glue to the wreath form and some to the rope where it would overlap to make sure that it adhered well.
Keep this going until you have covered the top and over to the outside edge. I repeated this until it hit the side that would touch the wall and I didn’t continue this on the backside as it wouldn’t be seen.
When I go to the end of a rope, I just started a new one right next to it.
Once completely wrapped to your liking, add some hot glue to the backside and wrap the nautical rope around 3 times around and then trim at the end adding hot glue to secure it. Repeat this 3 more times on the wreath and then cut a small piece to use as a hanger and adhere with hot glue.